This is a
A single click on the Z-Wave switch will confirm Inclusion and Exclusion.
This device take existing Z-WAVE signal, repeat and send it to a longer range where it is too far away for the controller (supporting FLiRS devices). Due to a special antenna amplifier the operating range will be up to 100 meters when installed correctly.
Plug the edvice into a free plug socket.
The LED will blink as long the deivce is not included into a Z-Wave network.
Note: For indoor use only!
After inclusion the LED will stop to blink. The extender is a passive device, that only extends your Z-Wave network"s range.
Reset to factory default | XXXResetDescription |
Inclusion | Single click on the program switch. |
Exclusion | Single click on the program switch. |
NIF | Single click on the program switch. |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Lifeline |
Dimensions | 0.0460000x0.0460000x0.0580000 mm |
Weight | 40 gr |
EAN | 1220000013247 |
Firmware Version | 01.06 |
Z-Wave Version | 03.43 |
Z-Wave Product Id | 0086.0004.0025 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |