Hunter Douglas
Blind Control 24V DC
SKU: HDL_DBMZ
Quickstart
This is a
A short push on the "LEARN" button confirms Inclusion and Exclusion. This button also issues a Node Information Frame.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The Hunter Douglas window blind control allows to control 24 DC motors of window blinds. The control is performed with polarity reversal, which makes this device suitable for a wide variety of window blind solutions among others Velux roof windows. Local operation is possible using two buttons.
Installation
The device requires an external power supply for 24 V DC with a minimum power of 12 W. Connect the two wires from the power supply in the right polarity with the terminals DC+ and DC-. The two wires from the DC Motor are connected to the terminals "Motor". It is recommended but not required to fix the device to a wall or a wall box using the two mounting holes on the enclosure side.
Calibration
To calibrate the traveling time of the blind a calibration process needs to be started right after installation. Keep the two buttons "OPEN" and "CLOSE" pushed for 10 seconds until the green motor LED shines. Now release the two buttons. Hit the "CLOSE" button to start the calibration sequence. The blind will now move between the end positions to detect the travel time.
Product Usage
The device is designed to control blind motors wirelessly. A local operation for tests is possible using the two buttons "OPEN" and "CLOSE".
| Reset to factory default | XXXResetDescription |
| Inclusion | A short push on the "LEARN" button confirms Inclusion and Exclusion. |
| Exclusion | A short push on the "LEARN" button confirms Inclusion and Exclusion. |
| NIF | short push on the LEARN button |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Configuration Parameters
Parameter 1: Calibration
Starts the calibration sequence (1 = start) Size: 1 Byte, Default Value: 00
| Setting | Description |
|---|---|
| 00 | Normal |
| 01 | Calibrate Command |
Parameter 2: Motor Direction
Defines the direction of the motor and starts calibration sequence Size: 1 Byte, Default Value: 00
| Setting | Description |
|---|---|
| 00 | normal |
| 01 | reverse |
Parameter 3: Tilt Feature
Allows precision positioning for wood blinds Size: 1 Byte, Default Value: 00
| Setting | Description |
|---|---|
| 00 | Disable |
| 01 | Enable |
Technical Data
| Dimensions | 0.0000000x0.0000000x0.0000000 mm |
| Hardware Platform | ZM3102 |
| Voltage | 24 V |
| Device Type | Window Covering No Position/Endpoint |
| Generic Device Class | Multilevel Switch |
| Specific Device Class | Multiposition Motor Switch |
| Firmware Version | 02.01 |
| Z-Wave Version | 02.28 |
| Certification ID | ZC08-09050004 |
| Z-Wave Product Id | 0033.5250.3032 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |