Heiman
Smart Temperature and Humidity Sensor
SKU: HEIEHS1HT
Quickstart
This is a
-If Inclusion Process is successful, Green LED will turn off.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Smart Temperature and Humidity Sensor is designed to detect the temperature and humidity in house, and reports the abnormal conditions to users‘ mobile phone, Users could also check the real-time temperature and humidity via mobile phone, The sensor adopts Z-Wave wireless communication protocol with high sensitivity.
Installation
Tear off the gummed film, stick the equipment in the required area.
Note that the mounting base shall be up as the direction of arrow shown in the graph. Finally, hang the detector into the mounting base.
Product Usage
Battery Report
- Battery Report is transmitted when power on the device.
- Battery Report is transmitted once a day.
- Battery Report is transmitted when the battery power falls less than 10%
|
Battery Voltage |
Battery Level |
|
2.4V ~ 3.0V |
10~ 100 (%) |
|
Under 2.4V |
0xFF |
| Reset to factory default | - Long press Network Button while installing batteries in the product |
| Inclusion | -Press the Network Button 3 times within 1.5s. The green LED is Blinking 3 times within 1 second. -If inclusion process is successful, green LED will turn off. |
| Exclusion | - Press the Network Button 3 times within 1.5s - If Exclusion Process is successful, the green LED is blinking 6 times, then turn off |
| NIF | XXXNIF |
| Wakeup | Wake up Notification is transmitted every 24 hours by default. Wake up Notification is transmitted after Notification Report is Transmitted. |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | Lifeline |
| 2 | 5 | Multilevel Sensor reports status of the temperature via Lifeline. When the sensor detects status of the temperature, the device will be triggered. |
| 3 | 5 | Multilevel Sensor reports status of the humidity via Lifeline. When the sensor detects status of the humidity , the device will be triggered. |
Technical Data
| Dimensions | 0.0550000x0.0550000x0.0150000 mm |
| Weight | 25 gr |
| Hardware Platform | ZM5202 |
| EAN | 6971348970284 |
| IP Class | IP 20 |
| Voltage | 3V DC |
| Battery Type | 1 * CR2450 3.0V |
| Device Type | Multilevel Sensor |
| Network Operation | Reporting Sleeping Slave |
| Z-Wave Version | 6.51.09 |
| Certification ID | ZC10-17055578 |
| Z-Wave Product Id | 0x0260.0x8007.0x1000 |
| Communications Protocol | Z-Wave Serial API |
| Supported Notification Types | Weather Alarm |
| IP (Ingress Protection) Rated | ok |
| Firmware Updatable | Not Updatable |
| Controller Supports Multiple Networks | ok |
| Communications Connections | Ethernet (Wireless/WiFi) |
| Sensors | Air TemperatureHumidity |
| Color | White |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |