Quickstart

This is a On/Off Power Switch for XXXQFrequencyName. To run this device please insert fresh 1 * 3,8V 700mAh batteries. To run this device please make sure the internal battery is fully charged. To add this device to your network execute the following action:

? Press the Net_Button 3 times within 1.5s, Green LED is Blinking 3 times within 1.5second.

? If add Process is successful, Green LED will turn off.

Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

?Smart Siren supports OTA function and S2 encryption function.

?Product support sound and light alarm.

?Product is S2 Unauthenticated devices.

?This device is a security enable Z?Wave Plus product that is able to use encrypted Z?Wave Plus messages to communicate to other security enable Z?Wave Plus products.

Note: A "Security Enable Z?Wave Controller" must bu used in order to fully utilize this function.

Product Usage

The device is powered on. The red LED is onfor two seconds to extinguish. The device is powered on. If the device is added to the gateway, the gateway can control the device alarm and cancel the alarm. When the alarm mode is used, the device emits an alarm sound and the red LED flashes.

?Backup battery:

The main power of the equipment is cut off, and the backup battery is used to keep the equipment on standby for 4 hours, and then the equipment can also be alarmed for 5 minutes.

Battery Report description

The battery is transmitted in half an hour

? Battery Report is transmitted when a battery falls less than 0%

Battery Voltage	Battery Level
3,7V ~ 4,1V	0 ~ 100 %
Under 3,7V	255 (0xFF)

Reset to factory default	Long press Net_Button at least 10 seconds in the product
Inclusion	? Press the Net_Button 3 times within 1.5s, Green LED is Blinking 3 times within 1.5second. ? If add Process is successful, Green LED will turn off.
Exclusion	? Press the Net_Button 3 times within 1.5second. ? If remove Process is successful, Green LED is Blinking 6 times, then turn off.
NIF	XXXNIF
Wakeup	XXXWakeupDescription
Protection	XXXProtection
FirmwareUpdate	XXXFirmwareUpdate
SetAssociation	XXXSetAssociation

Association Groups:

Group Number	Maximum Nodes	Description
1	5	Lifeline

Technical Data

Dimensions	0.0780000x0.0780000x0.0780000 mm
Weight	121 gr
Hardware Platform	ZM5202
EAN	6971348970345
IP Class	IP 20
Voltage	230 V
Battery Type	1 * 3,8V 700mAh
Device Type	On/Off Power Switch
Generic Device Class	Binary Switch
Firmware Version	01.01
Z-Wave Version	04.26
Certification ID	ZC10-18066158
Z-Wave Product Id	0x0260.0x8009.0x1000
Frequency	Europe - 868,4 Mhz
Maximum transmission power	5 mW

Heiman