This is a
a.Press & hold Inclusion/Exclusion button for 5 seconds when Open Sensor is exclusion status.b.LED of Open sensor will be on 5 seconds later.c.Open sensor will try Inclusion for 30sec when button is released.d.LED will blink 3 times if Inclusion is successful.
Remote Access via smart phone APPDetecting the status of Door/Windows equipped with Z-WAVE Open Sensor and notifying the status to a customer.Checking the battery usage and reporting the low battery alarm.
Reset to factory default | a.Press & hold Inclusion/Exclusion button for 10sec.b.LED will blink while holding the button.c.Factory reset will be done in 5sec after releasing button and LED will blink 5 times.Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
Inclusion | a.Press & hold Inclusion/Exclusion button for 5 seconds when Open Sensor is exclusion status.b.LED of Open sensor will be on 5 seconds later.c.Open sensor will try Inclusion for 30sec when button is released.d.LED will blink 3 times if Inclusion is successful. |
Exclusion | a.Receiver will stay exclusion waiting mode.b.Press & hold Inclusion/Exclusion button for 5 seconds when Open Sensor is Inclusion status.c.LED of Open sensor will be on 5 seconds later.d.Open sensor will try Exclusion when button is released.e.LED will blink 3 times if Exclusion is successful. |
NIF | XXXNIF |
Wakeup | a.Device sends Wake up Notification by every 15 minutes.b.Devices also sends Wake up Notification when inclusion/exclusionbutton is shortly pressed regardless of 15minutes interval. |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
Battery Report Period Value.The battery report period is in 15 minute increments.For example, the default value of 24 * 15 minutes = 360 minutes or 6 hours. Size: 1 Byte, Default Value: 24
Setting | Description |
---|---|
1 - 255 | Default 24 (0x18), 0x01~0xFF in 15 minute increments |
Hardware Platform | ZM5101 |
Device Type | Notification Sensor |
Network Operation | Reporting Sleeping Slave |
Firmware Version | HW: 1 FW: 39.20 |
Z-Wave Version | 6.61.00 |
Certification ID | ZC10-17065639 |
Z-Wave Product Id | 0x022c.0x0003.0x0001 |
Neutral Wire Required | ok |
Supported Notification Types | Access Control |
Color | White |
Firmware Updatable | Updatable by Professional/Technician |
Sensors | Open/Closed (Binary) |
Outdoor Use | ok |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |