This is a
The Flood Sensor is a universal Z-Wave compatible flood sensor indicating water leakage in Smart Homes. In case of a detected incident the device will send an alarm message to a central controller and can in parallel directly control a group of devices, e.g. to shut off water supply. On the device it self the water event will be indicated using a red LED and a buzzer. This behavior can be configured. The device can be mounted on a wall for easy maintenance and the water is detected using a cabled detector head. The cable is 90 cm long. The device can also be used without the mounting base and will then flow on the water surface.
The device can be placed on any flat surface in front or below home appliances such as dishwashers or washing machines as long as the opening gap is higher than 25 mm. The recommended way to install the device is to mount the mounting base on the lower part of the wall closed to the point of water leakage control. When mounted on a wall the device can be attached using the double sides tape on the backside of the device. However it is recommended to screw the device holder to the wall as seen above.
The detecting head is then connected to the base using a 90 cm long cable and can be placed even on placed with very limited room. To open the device turn the two parts of the enclosure against each other. The Z-Wave button is inside the enclosure.
Once placed on the desired location the device will alarm wirelessly and locally in case of a detected water leakage. The LED starts blinking and - if configured this way - the buzzer will sound. The sound will stop after 3 minutes even if the reason for the alarm was not removed. The LED will however continue to blink.
Reset to factory default | Reset to Default: 10s HOLD Device Reset (5seconds LED start blinking, success -> short beep) |
Inclusion | Single click the internal Button. The red LED will light up to confirm the action. |
Exclusion | Single click the internal Button. The red LED will light up to confirm the action. |
NIF | Single click the internal Button. The red LED will light up to confirm the action. |
Wakeup | Double click the internal Button. The red LED will light up to confirm the action. |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Lifeline |
2 | 5 | Water is detected |
This BASIC Command Value is sent on flood alarm to all devices in Association Group 2 Size: 1 Byte, Default Value: 255
Setting | Description |
---|---|
0 - 255 | BASIC Command Value |
This BASIC Command Value is sent on flood alarm clearance to all devices in Association Group 2 Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 - 255 | Basic Command Value |
Enable/Disable the Buzzer sound on active alarms. The LED will remain blinking even when the buzzer is deactivated. Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | Disabled |
1 | Enabled |
Dimensions | 68 x 68 x 34 mm |
Weight | 48.54 gr |
Hardware Platform | ZM5202 |
EAN | 4251295700052 |
IP Class | IP 44 |
Load | 1.3 yA |
Battery Type | 1 * CR123A |
Device Type | Notification Sensor |
Generic Device Class | Binary Sensor |
Specific Device Class | Alarm Notification Sensor |
Network Operation | Reporting Sleeping Slave |
Firmware Version | 00.03 |
Z-Wave Version | 04.05 |
Z-Wave Product Id | 0154.0004.0008 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |