Quickstart

This is a Notification Sensor for XXXQFrequencyName. To run this device please connect it to your mains power supply. To add this device to your network execute the following action:
Adding The Quickbox to your Z-Wave network (Inclusion):Prepare your Z-Wave controller to add a device to the network (refer to your controller's user manual.)Push the Z-Wave button on The Quickbox.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from Z-Wave Alliance Product data and may be incomplete. Please refer to the Manufacturers Manual for more information.

Product Description

TThe Quickbox is the perfect protection for your personal belongings such as jewelry, heirlooms, currency travel documents and much more!The Quickbox has cutting edge technology, state-of-the-art design, and incredible features that allows quick access to your valuables a reality.The Z-wave technology integration coupled with the RF + Biometrics allows for monitoring of your possessions right on your handheld devices. The QuickBox accentuates the protection of your belongings inside the home. Aircraft strength aluminum alloy provides added strength to the Quickbox.Product Features:360 Biometric fingerprint scannerNFC ScannerAircraft strength aluminum alloy shellInternal motion/vibration sensor with audible alarm2 USB ports for charging devices or connecting accessoriesZ-wave enabled technology

Reset to factory default Manual Reset:To reset The Quickbox Z-Wave settings to its factory defaults, hold the Z-Wave button for 5 seconds.Use the reset procedure only when the primary controller is missing or inoperable.
Inclusion Adding The Quickbox to your Z-Wave network (Inclusion):Prepare your Z-Wave controller to add a device to the network (refer to your controller's user manual.)Push the Z-Wave button on The Quickbox.
Exclusion Removing The Quickbox from your Z-Wave network (Exclusion):Prepare your Z-Wave controller to remove a device from the network (refer to your controller's user manual)Push the Z-Wave button on The Quickbox.
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Association Groups:

Group Number Maximum Nodes Description
1 5 Group 1 (u0022Lifelineu0022) sends Device Reset reports and tampering notifications when The Quickbox alarm state has changed.
2 5 Group 2 (u0022Tamper alarmu0022) sends tampering notifications when The Quickbox alarm state changes. (same as lifeline)
3 5 Group 3 (u0022Basic setu0022) sends Basic Set commands when The Quickbox alarm state changes.

Technical Data

Hardware Platform ZM5202
Device Type Notification Sensor
Network Operation Always On Slave
Firmware Version 02
Z-Wave Version 6.51.06
Certification ID ZC10-15060009
Z-Wave Product Id 0x023C.0x0001.0x0001
Frequency XXfrequency
Maximum transmission power XXantenna
U.S. / Canada / MexicoNotification Sensor