This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
The ZXT-110 is a Z-Wave to air-conditioner (AC) IR Extender that works with any Z-Wave compliant gateway or portable controller by translating Z-Wave&rsquos Thermostat commands and configuration commands to AC IR control code. User can set the IR code from the built-in code library of ZXT-110. It also supports Z-Wave networks with multiple gateways and controllers. Like every Z-Wave accessory, user will need to include the ZXT-110 into his Z-Wave network using the primary controller. Then, user can use either the primary controller or secondary controller to configure and setup the ZXT-110 using Z-Wave&rsquos configuration command class. Once the configuration and setup is completed, controller can use Z-Wave&rsquos “Thermostat commands class” to control their IR-controlled air-conditioner using the ZXT-110. ZXT-110 also supports battery operation that makes it very convenience as user can place it in anywhere at home.
Technical Data
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.0000000x0.0000000x0.0000000 mm |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |