Danfoss
Z-Wave temperature sensor
SKU: SCH_RS-Z
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
This Z-Wave device is used as a central temperature sensor for heating or cooling solutions with multiple actuators. The measured temperature is displayed. Two buttons allow to overwrite the setpoint temperature. It can be used as Z-Wave stand alone temperature sensor or to control heating, cooling of ventilation devices. The overwrite can be terminated for certain hours. After this time the setpoint temperature will go back to the redefined value.
Beside the two front buttons the device has one more button on the top side. The use of this button wan be defined by the central controller. Possible functions can include a temperature boost (heat up as soon as possible) or the activation of a energy saving mode.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Technical Data
| Dimensions | 0.0000000x0.0000000x0.0000000 mm |
| Certification ID | ZC08-14070002 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |