This is a
Press and hold the pairing button on the unit until the RF LED starts flashing at a fast rate. Then release the button. On successful inclusion the RF LED will stop flashing.
Secure Intelligent Relay is having One relay, and support of duration base schedule, measuring of temperature and delta and interval temperature reporting etc
A means of disconnection from the supply, having at least 3mm contact separation in both poles, must be incorporated in the fixed wiring. We recommend a separate fused circuit from the consumer unit (24-hour supply) protected by a 15A HRC fuse or, preferably a 16A MCB. In some cases immersion heater failure can damage the SIR. Installation of a 100mA RCD will provide additional protection for the unit. If the SIR is to be connected to a ring main then the spur feeding the controller should be protected in the same way. The SIR is NOT suitable for mounting on an unearthed metal surface.+
Reset to factory default | XXXResetDescription |
Inclusion | Press and hold the pairing button on the unit until the RF LED starts flashing at a fast rate. Then release the button. On successful inclusion the RF LED will stop flashing. |
Exclusion | Press and hold the pairing button on the unit until the RF LED starts flashing at a fast rate. Then release the button. On successful inclusion the RF LED will stop flashing. |
NIF | Press the Z-Wave Button |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 4 | Nodes to receive Schedule report |
2 | 4 | Nodes to receive multilevel sensor report Note: Group-2 is available only when external temp sensor is connected. |
Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 - 255 | Value |
Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 - 127 | °C |
128 - 255 | °F |
Size: 2 Byte, Default Value: 0
Setting | Description |
---|---|
1 - 65534 | Seconds |
Size: 2 Byte, Default Value: 0
Setting | Description |
---|---|
1 - 100 | °C in 0,1°C |
1 - 500 | °F in 0,1°F |
Size: 2 Byte, Default Value: 0
Setting | Description |
---|---|
1 - 1000 | °C in 0,1°C |
320 - 2120 | °F in 0,1°F |
Dimensions | 85x85x44 mm |
Weight | 123 gr |
Hardware Platform | ZM3102 |
EAN | 5015914083563 |
IP Class | IP IP 20 |
Voltage | 230 V |
Load | 3000 W |
Device Type | Central Controller |
Generic Device Class | Binary Switch |
Specific Device Class | Specific Device Class not used |
Z-Wave Version | 4.53 |
Certification ID | ZC08-14040014 |
Z-Wave Product Id | 0x0059.0x0010.0x0002 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |