Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1) Prepare the controller for enabling inclusion2) Keep touching the lamp low button, then after 5 seconds elapsed, 3 beep sounds can be heard. At that time, withdraw touching the button and then inclusion will be commenced.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
U+ Switch enables Light ON/OFF remotely with capacitive touch buttons and wireless connection(Z-Wave)
| Reset to factory default |
(* Use this procedure only when the network primary controller is missing or otherwise inoperable.)1) Hold the low touch button for 10 seconds - Keep holding the button, then at 5 second, 3 beeps will come out, and keep holding- 10 seconds later, 5 beep sounds can be heard, and then withdraw touching the low button, so that factory reset should be started.2) After factory reset is done, all the lamps will be turned off and all variables will be initialized to default values. |
| Inclusion |
1) Prepare the controller for enabling inclusion2) Keep touching the lamp low button, then after 5 seconds elapsed, 3 beep sounds can be heard. At that time, withdraw touching the button and then inclusion will be commenced. |
| Exclusion |
1) Make sure the switch is in inclusion mode.2) Keep touching the lamp low button, then after 5 seconds elapsed, 3 beep sounds can be heard. At that time, withdraw touching the button and then exclusion will be started. |
| NIF |
XXXNIF |
| Wakeup |
Light Switch is always wake up status. |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 2 |
6 |
Z-Wave Plus Lifeline |
Technical Data
| Hardware Platform |
ZM5101 |
| Device Type |
On/Off Power Switch |
| Network Operation |
Always On Slave |
| Firmware Version |
01 |
| Z-Wave Version |
6.51.06 |
| Certification ID |
ZC10-15070013 |
| Z-Wave Product Id |
0x0233.0x0049.0x0001 |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |