Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The Swiid Cord Switch is the first Z-Wave cable switch applied for lamps and other devices with classic cable connection. The device replaces an existing cable switch or can be easily extend a normal cable without an integrated switch. Therewith the Swiid Cord Switch can be used the same way as an ordinary cable switch or via Z-Wave wireless technology. That allows additional association with motion sensors or wireless wall switches. An association of several lamps is also possible but this depends on the used controller.

Features:

  • Cord switch with integrated Z-Wave radio
  • Replaces existing cable switches or extends connector cables without switch
  • Wireless Technology: Z-Wave

 

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0300000x0.0820000x0.0300000 mm
Weight 40 gr
EAN 3700925910022
Certification ID ZC08-14070005
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeZ-Wave Device