Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
Once the controller is in inclusion mode, remove the battery pull tab OR insert the battery to power up the sensor.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
For indoor use onlyOperating frequency: 908.42 MHzOperating range: Up to 100 feet (30.5 meters) line-of-sightOperating temperature: 0C to 49C, 32F to 120F (ambient temperature)Battery type: 3V Lithium CR123ABattery life: 5 to 8 years depending upon operating conditions
Reset to factory default |
To reset the sensor to factory default, place the controller in exclusion mode and then insert the battery into the sensor to initiate power up.Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. |
Inclusion |
Once the controller is in inclusion mode, remove the battery pull tab OR insert the battery to power up the sensor. |
Exclusion |
Once the controller is in exclusion mode, remove the battery pull tab OR insert the battery into the sensor to initiate power up. |
NIF |
XXXNIF |
Wakeup |
Simply remove the sensor cover to wake up for configuration. |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
2 |
5 |
Created to communicate directly to other local Z-Wave devices. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-16030002 |
Z-Wave Product Id |
0x014A.0x0004.0x0003 |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |