This is a
Pressing On/Off button three times within 1.5seconds will enter inclusion mode.
Reset to factory default |
|
Inclusion | Pressing On/Off button three times within 1.5seconds will enter inclusion mode. |
Exclusion | Pressing On/Off button three times within 1.5 seconds will enter exclusion mode. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | On/Off righ switch (Lifeline) |
2 | 5 | On/Off left switch |
3 | 5 | On/Off dopple klick righ switch |
4 | 5 | All On/Off |
Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | off |
1 | on |
Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | off |
1 | on |
Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 - 1 | Invert switch |
Setting | Description |
---|---|
0 | Off |
1 | 1 second |
2 | Constantly |
You may wish to disable transmitting commands to Z-Wave devices that are in Group 4 without “disassociating” those devices from the group. Setting parameter 5 to the value of 1 will stop the switch from transmitting to devices that are “associated” into Group 4. Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | sending |
1 | not sending |
Dimensions | 0.0800000x0.0800000x0.0380000 mm |
Weight | 87 gr |
Hardware Platform | ZM5202 |
EAN | 695917446647 |
IP Class | IP IP 20 |
Voltage | 230 V |
Load | 1380 W x 2 |
Device Type | Two channel wall switch |
Generic Device Class | Binary Switch |
Specific Device Class | Binary Power Switch |
Firmware Version | 02.00 |
Z-Wave Version | 04.05 |
Z-Wave Product Id | 0x0118.0x0003.0x0001 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |