Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
1. Have Z-Wave controller with inclusion mode
2. Press the socket on/off button three times within 1.5 seconds to be included to the controller
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Product Description
1. This plug-in ON/OFF switch in a transceiver which is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network.
2. Each socket is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure the signal to ensure that the signal is received by its intended destination.
3. You can use the button in the socket to include/exclude, manually on/off or act as a indicator. You can use it to turn on/off appliance remotely via smart phone or computer.
Reset to factory default |
1. Press the socket on/off button three times within 1.5 seconds
2. then within 1 second to press and hold on for 5 seconds until the socket button LED is off, reset to factory default successfully
3. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable
|
Inclusion |
1. Have Z-Wave controller with inclusion mode
2. Press the socket on/off button three times within 1.5 seconds to be included to the controller |
Exclusion |
1. Have Z-Wave controller with exclusion mode
2. Press the socket on/off button three times within 1.5 seconds to be excluded from the controller |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Z-Wave Plus Lifeline The Switch can be set to send reports to control associated Z-Wave devices. It supports one association group with one node support for Grouping 1. For group 1, the Switch will report its latest status to Z-Wave Controller. Grouping 1 includes, SWITCH_BINARY_REPORT, ALARM_REPORT |
Technical Data
Dimensions |
102*60*75 mm |
Weight |
127 gr |
Hardware Platform |
ZM5202 |
EAN |
6959174468212 |
Device Type |
On/Off Power Switch |
Network Operation |
Always On Slave |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-15100001 |
Z-Wave Product Id |
0x0118.0x0003.0x0004 |
Frequency |
Europe - 868,4 Mhz |
Maximum transmission power |
5 mW |