This is a
To include the device into the network, turn the controller into the inclusion mode and then press the upper or lower part of the paddle of the device. The device is now ready to work.
The TZ65-S single wall dimmer is switching attached loads and is controlled either by the local switching paddle or remotely via the Z-Wave wireless protocol. It is included and controlled in a Z-Wave network by a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software. Beside the local switch the unit can control other Z-Wave units remotely in up to three additional Z-Wave groups, which are associated with this device. Tipping one time or two times the switching paddle performs the control. The association of further Z-Wave devices needs to be done by a Z-Wave controller. The unit is powered by 230V power and needs a pattress box with 230 V power wires for installation.
The unit is shipped completely with electronics, switching paddle and mounting frame in arctic white HomePro style, which can be replaced by another mounting frame of the HomePro switching series. The unit is designed for use within a 3-wire system, which means that a neutral wire (blue) is needed for operations.
The TZ65-S wall mounted switch needs a pattress box with 230 V power wires for installation. It does not fit into German wall boxes with 60 mm diameter.
The actuator is operated by the local switching paddle or wirelessly using Z-Wave commands. If the insert is mounted correctly pushing the upper part of the paddle will turn ON the load. Pushing the lower part of the paddle will turn OFF the electric load. Pressing and holding the switch will allow dimming and brightening of Z-Wave dimmers if associated.
The device is also able to report status changes to a controller (communication pattern 2) and to remotely operate other devices by sending wireless Z-Wave commands.
Reset to factory default | XXXResetDescription |
Inclusion | The device is excluded and included by a single click on the switch when the controller is in exclusion resp. inclusion mode. |
Exclusion | The device is excluded and included by a single click on the switch when the controller is in exclusion resp. inclusion mode. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | every switching command |
defines if the start level bit shall be ignores when transmitting a dim command to a dimmer Size: 1 Byte, Default Value: 01
Setting | Description |
---|---|
00 | ignore |
01 | dont ignore |
Activates Night Light Size: 1 Byte, Default Value: 00
Setting | Description |
---|---|
00 | LED blinks on activity |
01 | Night Light active |
Inverts Switching (on is upper part) Size: 1 Byte, Default Value: 00
Setting | Description |
---|---|
00 | dont invert |
01 | invert |
defines the behavior of the LED when transmitting data Size: 1 Byte, Default Value: 00
Setting | Description |
---|---|
00 | no flicker |
01 | flicker all time of data transmission |
02 | flicker for one second only |
Dimensions | 0.0840000x0.0840000x0.0470000 mm |
Weight | 106 gr |
EAN | 6959174465501 |
Device Type | Light Dimmer Switch |
Generic Device Class | Multilevel Switch |
Specific Device Class | Routing Multilevel Switch |
Firmware Version | 01.03 |
Z-Wave Version | 03.28 |
Certification ID | ZC08-12110001 |
Z-Wave Product Id | 0118.0808.0808 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |