TKB Home
Z-Wave Wall Plug Dimmer for Typ F
SKU: TKB_TZ67-F
Quickstart
This is a
Inclusion and Exklusion are confirmed by hitting the button one time.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The TKB TZ67 is a dimmer plug that can be placed between a wall outlet for Typ F Plug and electric devices, plugged in by cord. It can dim resistive loads up to 300 W. The device is IP 20 rated and can therefore only be used in dry environments. For dimming the devices apply leading edge phase cutting. It is therefore only possible to dim incandescent lamps and high voltage halogen lights. Low voltage halogen lights, LEDs and CFLs must not be attached. Dimming is controlled wirelessly using Z-Wave or locally applying a button. A blue LED indicates the dimming status.
Installation
The Dimmer Plug can be plugged into every wall outlet for Plug-Type F (France, Poland, ...). It is IP20 rated and can therefore only be used in dry environments. Do not locate the device facing direct sunlight, humid or dusty place. The suitable ambient temperature for the device is 0°C ~ 40°C.
Product Usage
The device is able to dim electric load up to 300 W. Short press of the button will toggle. This means that the power will be turned on if it was off and turned off when it was on. When switching the lamp on or off the light will dim for about 2 seconds until the final level is reached.
The the button is constantly pressed the light will be dimmed. The dimming function will also toggle. Constantly pressing the the button will either dim up or dim down the light until it reaches the final level.
| Reset to factory default | XXXResetDescription |
| Inclusion | hit the button on the device. |
| Exclusion | hit the button on the device. |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Technical Data
| Dimensions | 0.0600000x0.1020000x0.0760000 mm |
| Weight | 136 gr |
| Hardware Platform | ZM3102 |
| IP Class | IP 20 |
| Voltage | 230 |
| Load | 400W |
| Device Type | On/Off Power Switch |
| Generic Device Class | Binary Switch |
| Specific Device Class | Binary Power Switch |
| Firmware Version | 01.04 |
| Z-Wave Version | 03.28 |
| Certification ID | ZC10-16025011 |
| Z-Wave Product Id | 0118.0101.0103 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |