Vision Security
Siren with DC adapter
SKU: VISEZM1602-5
Quickstart
This is a
To get in the “inclusion” mode, the distance between siren and controller is suggested to be in one meter. Open the bracket and press the program switch of ZM 1602 for 1 second at least & release to be included. After setting, the LED Setting Lighting should go off.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
This product will sound a loud siren and flash a strobe light when an alarm message or alert is received on any Z-Wave enabled network. This siren is a Z-Wave enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any Z-Wave enabled network. Configuration modes are provided to select; Strobe, Siren or Both and to set Alarm Auto Stop time. Features also include Self-Protection (tamper proof) alert and 105dB siren at 1 meter.
Installation
| Reset to factory default | All user and network settings will be cleared and the device reset to factory defaults when the device is excluded. |
| Inclusion | To get in the “inclusion” mode, the distance between siren and controller is suggested to be in one meter. Open the bracket and press the program switch of ZM 1602 for 1 second at least & release to be included. After setting, the LED Setting Lighting should go off. |
| Exclusion | Press the Tamper Switch of ZM 1602 for 1 second at least & release to be excluded. |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | Support OTA Firmware update from controller. |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | LifeLine association for central static controller |
Configuration Parameters
Parameter 1: Siren/Strobe Mode
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | All Enable |
| 1 | Siren only |
| 2 | Storbe only |
Parameter 2: Alarm Auto Stop Time
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | 30 seconds |
| 1 | 60 seconds |
| 2 | 120 seconds |
| 3 | unlimited |
Technical Data
| Dimensions | 115x77x38 mm |
| Weight | 130 gr |
| Hardware Platform | ZM5202 |
| EAN | 0019962005602 |
| IP Class | IP 20 |
| Voltage | 12V - 39V DC 9V - 28V AC |
| Device Type | Siren |
| Generic Device Class | Binary Switch |
| Network Operation | Always On Slave |
| Firmware Version | 0f.05 |
| Z-Wave Version | 04.05 |
| Certification ID | ZC10-15050007 |
| Z-Wave Product Id | 0109.2009.0908 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |