Vision Security
Door- and Window Sensor
SKU: VIS_ZD2102
Quickstart
This is a
A single click on the tampering switch inside the enclosure will confirm Inclusion and Exclusion. Releasing the tampering switch will wake up the device and keep it awake.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
This sensor offers information whether a door or window is open or closed. The product consists of a magnetic element and the main unit. One of the parts is mounted on the moving part of the window or of the door. The other part is placed on the frame. The installation can be done with screws or double-sided tape. The 2102 is a battery-powered device, which is in sleeping mode unless an action is detected. After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping modus. Batteries can be changed without unscrewing the device from the door or frame. The units send information to a controller or any other associated Z-Wave device.
Installation
1. Unscrew the screw fastening on the cover and slide the cover down.
2. Insert the CR123A battery into the batter compartment and the LED will start to flash slowly. This means that the sensor is not yet included into a Z-Wave network.
3. Use the screws or adhesive tape to fix the cover on the frame along the opening edge of the door or window. See figure below.
Product Usage
Whenever the door or the window where the sensor is mounted will open or close the device will send out a wireless signal.
| Reset to factory default | XXXResetDescription |
| Inclusion | A single click for one second on the tampering switch inside the enclosure will confirm Inclusion and Exclusion. |
| Exclusion | A single click for one second on the tampering switch inside the enclosure will confirm Inclusion and Exclusion. |
| NIF | A single click on the tampering switch inside the enclosure will send out a Node Information Frame. |
| Wakeup | Releasing the tampering switch will wake up the device and keep it awake. |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | BASIC command when sensor is tripped |
Technical Data
| Dimensions | 0.0250000x0.0870000x0.0210000 mm |
| Weight | 24 gr |
| EAN | 0696859123450 |
| Battery Type | 1 * CR123 |
| Device Type | Routing Binary Sensor |
| Generic Device Class | Binary Sensor |
| Specific Device Class | Routing Binary Sensor |
| Firmware Version | 04.54 |
| Z-Wave Version | 03.28 |
| Certification ID | ZC08-12100008 |
| Z-Wave Product Id | 0109.2001.0102 |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |