Quickstart

This is a secure Z-Wave Device for XXXQFrequencyName. To run this device please insert fresh 4 * AA batteries. To run this device please make sure the internal battery is fully charged.

To confirm Inclusion and Exclusion insert the following Key sequence on the key pad: "C" + "8" + "8" + "8" followed by turning the handle on the inside of the door lock. The operation is confirmed by a long beep.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The ZM1702 is a Z-Wave controllable door lock that fits into standard European doors. The mechanics can be adopted to right or left opening doors. The door lock can be applied for doors from a thickness of 38 mm and up. Since the lock is just a single dead bold lock it will not replace modern three dead bold locking outer doors. The door can be locked and unlocked using the inner side turn piece and/or the key pad. The wireless control allows to lock/unlock the lock, set/unset up to 15 different key codes (4...8 key long) and to limit the validity of certain key code.

Note: The distance between the center of the handle axle and the center of the key insert is 88 mm. If the lock shall be used to retrofit an existing door, the original handle lock distance needs ot be similar.

Scope of Delivery:

  • inner plate with handle and turn piece
  • outer plate with handle and key pad
  • inner lock mechanics
  • cylinder with 3 keys

Installation

Dimensions of the door

Change Orientation of the Handle

  • Remove the Retaining Ring on both handles and remove the metal plate.
  • If handle is on the left hand side (seen from outer door side) place the spring and the metal plate like below.
  • If you want the handle on the right hand side (seen from the outer door side), place the spring and the metal plate like below. Apply the retaining ring again.
  • If needed change the latchbolt direction as described in the manual supplied with the product.

Product Usage

  • Please press "C", then enter a valid user code and press to unlock the door. User shall hear one beep and light is green. If code is invalid, user shall hear one beep and light is red.
  • If user press invalid code during process, please press "C" to start over.
  • The Electronic Deadbolt Lock supports up to 13 sets of User code (including Master code). Each number combination can be 4 digits to 10 digits.
  • The devices supports up to 50 schedule slots (year, month, day, time) to Entry lock for all user in the system.
Visual feedback message definitions:
  • Valid Programming: one long beep and light is green.
  • Invalid Programming: one long beep and light is red.
  • Lock error: three long beeps and lights red flash.
  • Low battery warning: Beeps and lights red flash 5 seconds. Please replace with good quality alkaline batteries. Note: Please re-enter Year-Month-Date-Hour-Minute after batteries are complete dead.

Reset to factory default XXXResetDescription
Inclusion

 insert the following Key sequence on the key pad: "C" + "8" + "8" + "8" followed by turning the handle on the inside of the door lock. The operation is confirmed by a long beep.

Exclusion

 insert the following Key sequence on the key pad: "C" + "8" + "8" + "8" followed by turning the handle on the inside of the door lock. The operation is confirmed by a long beep.

NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.1550000x0.2540000x0.1600000 mm
Weight 1700 gr
Hardware Platform ZM3102
EAN 0696859123498
Battery Type 4 * AA
Firmware Version 03.0f
Z-Wave Version 02.61
Certification ID ZC08-13120003
Z-Wave Product Id 0109.2006.0610
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeZ-Wave Device