This is a
A single click on the tampering switch inside the enclosure will confirm Inclusion and Exclusion. Releasing the tampering switch will wake up the device and keep it awake.
This sensor detects any vibration or shock of the device it is mounted to. It can therefore be used to protect any valuable goods, windows, doors or any other kind of gear that is not supposed to move or vibrate. The sensor has a manual calibration and adjustment element to adapt the sensitivity to the different applications. The installation can be done with screws or double-sided tape. The device is battery-operated and therefore in sleeping mode unless an action is detected. After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping modus. Batteries can be changed without unscrewing the device from the door or frame. The unit will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced. The units send information to a controller or any other associated Z-Wave device. Up to 5 devices can be controlled from this device. A tamper switch protects the device from removal or manipulation if used in security applications. Two terminals allows the connection of an external dry contact in parallel to the vibration sensor. The powerful CR123 Lithium battery lasts 3 ... 5 years in normal operation conditions. The device supports normal Z-Wave inclusion, auto inclusion and network wide inclusion for convenient handling.
There are two options to mount the sensor. Double sides tape can be applied to the mounting plate or the device itself. Screws however offer a more solid mounting and are stongly recommended for all security-related applications.
Sensitivity Adjustment:
The installed vibration sensor will send out a wireless signal every time a vibration is detected.
Reset to factory default | XXXResetDescription |
Inclusion | A single click for one second on the tampering switch inside the enclosure will confirm Inclusion and Exclusion. |
Exclusion | A single click for one second on the tampering switch inside the enclosure will confirm Inclusion and Exclusion. |
NIF | A single click on the tampering switch inside the enclosure will send out a Node Information Frame. |
Wakeup | Releasing the tampering switch will wake up the device and keep it awake. |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Send Command when shock is detected |
Dimensions | 75x42x26 mm |
Weight | 150 gr |
Hardware Platform | ZM3102 |
EAN | 0696859123467 |
IP Class | IP 20 |
Battery Type | 1 * CR123 |
Device Type | Routing Binary Sensor |
Generic Device Class | Binary Sensor |
Specific Device Class | Routing Binary Sensor |
Firmware Version | 04.54 |
Z-Wave Version | 03.28 |
Z-Wave Product Id | 0x0109.0x2003.0x0302 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |