Zipato

RGBW BULB 2

SKU: ZIPERGBW2

ZWave+ Security

Quickstart

This is a secure Bulb for XXXQFrequencyName. To run this device please connect it to your mains power supply. To add this device to your network execute the following action:
- Toggle the wall-switch, from OFF, then to ON.
- The bulb will flash once when it has been included into the network



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

Zipato Bulb 2 has 5 color channels available for you to adjust: RED, GREEN, BLUE, WARM WHITE and COLD WHITE. 
Zipato Bulb 2 can be used to add color to your home or just to lighten it up in any white color tone you desire. By using Zipatile or Zipabox (or other Z-Wave) home controller, you can control the bulb from anywhere in the world, by using any smartphone (iOS or Android). Also, you can automatically set colors of your Zipato Bulb 2 to indicate events using the Zipato rule creator.

Installation

1. Screw the Zipato Bulb 2 into the socket
2. Activate inclusion mode on your Z-Wave controller
3. Turn ON your wall switch
4. Inclusion process will be started automatically

Product Usage

Zipato does not recommended the use of a line voltage dimmer with bulbs. The reason is that each bulb contains a radio and by reducing or removing power through a line voltage dimmer may cause the connected bulb to not function properly.
For dimming, Zipato recommends using a compatible Z-Wave controller and assoicated application (i.e., Zipato?s Android or iOS application) or a compatible wireless switch that uses the same wireless protocol as the bulb.
Reset to factory default To manually reset the bulb switch it on and off 6 times for intervals of 0,5 to 2 seconds. After the 6th time, the bulb will flash twice indicating that it?s succesfully reset.
Inclusion - Toggle the wall-switch, from OFF, then to ON.
- The bulb will flash once when it has been included into the network
Exclusion - Toggle the wall-switch, from OFF, then to ON.
- The bulb will flash once and then dim to 5% when it has been excluded outside the network. If you want the bulb to be reincluded, you need re-power the bulb, and then execute the inclusion process.
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Association Groups:

Group Number Maximum Nodes Description
1 1 Lifeline

Configuration Parameters

Parameter 1: Bulb temperature

Read only
Size: 1 Byte, Default Value:

Setting Description
1 - 100 Value

Parameter 255: Factory default


Size: 4 Byte, Default Value: 1

Setting Description
2290649224 Factory default

Technical Data

Dimensions 0.0600000x0.1200000x0.0600000 mm
Weight 130 gr
Hardware Platform ZM5202
EAN 3858890733464
IP Class IP 20
Voltage 230V
Load 9,5W
Device Type Bulb
Firmware Version 02.00
Z-Wave Version 04.26
Certification ID ZC10-17115890
Z-Wave Product Id 0x0131.0x0002.0x0003
Frequency Europe - 868,4 Mhz
Maximum transmission power 5 mW
EuropeBulb