This is a
For Inclusion in (adding to) a network: Put the Z-Wave Interface Controller into inclusion mode, and following its instruction to add the ZL 7435EU-5 to your controller.To get in the inclusion mode, the distance between module and controller is suggested to be in one meter. Press 3 times within 2 seconds or turn on the wall switch 3 times within 2 seconds (or press toggle switch 3 times) to be included.
* Super Mini Size: 39.5x 50 x 19 mm* Operating Range: Up to 100 feet line of sight* Operating Temp.: -15C~ 60C (5F~140F)* Operating Voltage: 100VAC~240VAC* Resistive Load:550W110 VAC 1100W220 VAC
Reset to factory default | Factory Default Reset: Power off first, press Program Switch and power on till 10 seconds, ZL7435EU-5 will send the Device Reset Locally Notification command and reset to the factory default. (Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.) |
Inclusion | For Inclusion in (adding to) a network: Put the Z-Wave Interface Controller into inclusion mode, and following its instruction to add the ZL 7435EU-5 to your controller.To get in the inclusion mode, the distance between module and controller is suggested to be in one meter. Press 3 times within 2 seconds or turn on the wall switch 3 times within 2 seconds (or press toggle switch 3 times) to be included. |
Exclusion | For Exclusion from (removing from) a network: Put the Z-Wave Interface Controller into exclusion mode, and following its instruction to delete the ZL 7435EU-5 from your controller. Press 3 times within 2 seconds or turn on the wall switch 3 times within 2 seconds (or press toggle switch 3 times) to be excluded. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
This parameter sets the mode for the wall switch inputs. Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Switch Mode (Default) |
1 | Toggle Mode |
Hardware Platform | ZM5101 |
Device Type | On/Off Power Switch |
Network Operation | Always On Slave |
Firmware Version | 02 |
Z-Wave Version | 6.51.06 |
Certification ID | ZC10-15110013 |
Z-Wave Product Id | 0x0109.0x2017.0x1719 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |