Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The Certified Installer Toolkit (CIT) is a tool for installers to test a Z-Wave network prior to completion to ensure a robust, reliable mesh network is in place, and a powerful tool for troubleshooting and diagnosing problems. It may be left behind for logging or even permanent off-site maintenance. 

Developed by the Z-Wave Alliance with the latest capabilities and offerings; the Z-Wave Certified Installer Toolkit is a powerful, versatile tool for every installer:

    • Comprehensive network diagnostics and device management, accessible from anywhere in the world
    • Rapidly identifies potential problems
    • Spectrum analyzer shows noise in the Z-Wave channels
    • Routing table displays which nodes are neighbors
    • Network map graphically displays how nodes are connected to each other
    • Z-Wave network sniffer (ZNiffer) will show what is actually sent by nodes and identifies the type of message
    • Displays advanced node information such as device version, battery level, Z-Wave library version, and more
    • Access to Z-Wave device product information including manuals and technical data
    • The CIT may be left at a site for long-term testing allowing you to connect to it remotely
    • The CIT is Z-Wave Plus certified as a controller
    • As a fully capable controller it can set configuration parameters and communicate with all nodes on the network, including those using Z-Wave S0 security
    • The CIT comes ready for several languages
    • It can only be used for North American Z-Wave frequency (908,42 MHz) - for other frequencies please refer to CIT for E or CIT for H

ATTENTION!  This product is available for Z-Wave Alliance members only.  You will need to provide the registered emailaddress of your Z-Wave Alliance Account to purchase the device. Please check here If you have valid Alliance Account credentials on hand. The same credentials are needed for initial configuration of the CIT.

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0900000x0.0270000x0.0700000 mm
Weight 85.17 gr
EAN 4251295700328
Frequency USA - 908.4MHz, 916MHz
Maximum transmission power 5 mW
USAZ-Wave Device