Z-Wave.Me
Dimmer Bypass
SKU: ZME_BYP
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The ZME bypass allows operating small loads on Z-Wave controlled 2-wire dimmers. In the two-wire system the electronics of the dimmer or switch is powered by one wire coming from the mains supply plus one wire that comes from the load itself. This means that even when the load is turned off a small current runs tru the load tin order to power the Z-Wave electronic. This small current can cause a small load (e.g. a LED bulb with only 9 W) to flicker even when powered off. This flickering will also impact the dimming.
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Technical Data
| Dimensions | 0.0100000x0.0170000x0.0180000 mm |
| EAN | 000000000000 |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |