This is a
***SELL OUT***
This calibration subsystem will work with the Z-Wave.Me Programmer or the Sigma Programmer provided as part of the System Development Kit. It allows recalibrating Z-Wave modules or initially calibrating designs based on the SD350x. The device has a built in power supply and a 4-signal connector to connect to the Programmer.
Reset to factory default | XXXResetDescription |
Inclusion | XXXInclusionDescription |
Exclusion | XXXExclusionDescription |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Dimensions | 0.0000000x0.0000000x0.0000000 mm |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |