This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Fibars Home Center Lite is a consumer electronics device used for home automation. This small sized (90x90x33 mm) gateway communicates and manages up to 230 devices wirelessly using Z-Wave.
The new Home Center Lite controller allows for even greater integration of home multimedia with the Fibaro System (in case multimedia devices are compatible with the system). Manage your TV, home cinema, Hi-Fi and others by the FIBARO App. Play with scenes and associations, change channels and adjust volume. Using Fibaro, you don&rsquot need any other remote than your smart phone or tablet.
Thanks to the built in power management functionality, you can monitor the current energy consumption and the power consumption history while being able to spot the devices consuming the most of it. Detailed statistics are presented as clear charts, helping you compare numbers and estimate upcoming bills.
The Home Center Lite is equipped with a mighty, incredibly energy efficient Cortex A8 processor (720MHz).
Compared to the Fibaro Home Center 2 the Home Center Lite supports no VoIP, no voice control and no scripting language for advanced scene control.
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.0900000x0.0900000x0.0330000 mm |
Weight | 139 gr |
Certification ID | ZC08-15070006 |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |