Z-Wave Europe
Z-Wave.Me Switch Set for Busch-Jaeger DURO 2000
SKU: ZMR_FMSW
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
This pattress box insert of the manufacturer Duwi is intended to control all kinds of electrical loads. The product consists of:
&bull the insert, which can be used with or without local control (equals ZME_06431)
&bull a special mounting plate to moount the insert into a pattress box
&bull a mounting frame in Busch Jager Duro 2000 series , color standard white
&bull the switching paddle for local control of the dimmer
The unit is designed for use within a 3-wire system, which means that a neutral wire (blue) is needed for operations. It will be included and controlled in a Z-Wave network from a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.
Technical Data:
- Power rating: 230V, 50 Hz
- Wiring: 3-wire-system
- Maximum loads: 2300W
- Wireless behaviour: receiver
- Z-Wave type: slave
- Installation: in pattress box
- Distance: up to 30 m in buildings
- Display: Multicolour-LED
- Interaction: two buttons to be completed with switching paddle for local operation
- Power supply: via 230 V power
- Dimensions: 48mmx48mmx23mm
The Z-Wave.Me switching Flush-Mountable bundle consists of standard DUWI Z-Wave hardware but located with an enhanced Z-Wave.Me firmware. The Flush-Mountable has two buttons.
Compared to the standard Duwi firmware this product offers a series of important enhancements:
- Works well within networks controlled by an IP gateway
- status changes are reported back to IP gateway in real time
- switching paddles can be used to control scenes in gateway
- Implements the most recent advancements of Z-Wave technology Explorer Frame for network wide inclusion and automated reconfiguration of networks
- Improved routing algorithm for faster communication
- Prevention against „Ghost Nodes“ after controller reset
Further enhanced features include
- Configurable night light
- Three association groups (single click, double click, status change)
- Switching paddle can be used for control independently of local operations
| Reset to factory default | XXXResetDescription |
| Inclusion | XXXInclusionDescription |
| Exclusion | XXXExclusionDescription |
| NIF | XXXNIF |
| Wakeup | XXXWakeupDescription |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Technical Data
| Dimensions | 0.0520000x0.0520000x0.0300000 mm |
| Weight | 55 gr |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |