Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The ZME_SERIAL is a little daughter board that connects a serial interface to the Wireless Z-Wave networks. The interface to the host is done by a 5x1 jumper connector that can be used in normal position and upside down. The pinout is (3.3V, TXD, RXD,GND, NC). The connection to the antenna is done using a reverse pigtail connector. The module itself contains a Z-Wave 300 chip preloaded with a Z-Wave.Me Z-Wave firmware and a 32 K EEPROM. There is an additional 2x5 pin programming connector compatible to the 2x5 connection of the Sigma Designs Programmer.
The firmware implements a superset of the Sigma Designs Serial Interface including some Z-Wave.Me specific  functions such as backup and restore or change of Vendor ID.

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0270000x0.0320000x0.0060000 mm
Frequency XXfrequency
Maximum transmission power XXantenna
RussianZ-Wave Device