Quickstart

This is a Z-Wave Device for XXXQFrequencyName. To run this device please connect it to your mains power supply.



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

The Raspberry 1 B+ board is a small PC to develop your own IOT projects. The board is features with a slim size but high performance. 

In combination with the Razberry module by Z-Wave.Me you can easily build a powerful Smart Gateway. Use the Raspberry 1 B+ as the base and plug on the Razberry module. Thanks to the included license for the Smart Home Software Z-Way you can build an own Smart Home Gateway in just a few steps.  

Features:

  • Chip Broadcom BCM2835 SoC
  • Core architecture ARM11
  • CPU 700 MHz Low Power ARM1176JZFS Applications Processor
  • GPU Dual Core VideoCore IV® Multimedia Co-Processor
  • Provides Open GL ES 2.0, hardware-accelerated OpenVG, and 1080p30 H.264 high-profile decode
  • Capable of 1Gpixel/s, 1.5Gtexel/s or 24GFLOPs with texture filtering
  • and DMA infrastructure
  • Memory 512MB SDRAM
  • Operating System Boots from Micro SD card, running a version of the Linux operating
  • system
  • Dimensions 85 x 56 x 17mm
  • Power Micro USB socket 5V, 2A (power adapter not included)
  • Ethernet 10/100 BaseT Ethernet socket
  • Video Output HDMI (rev 1.3 & 1.4)
  • Composite RCA (PAL and NTSC)
  • Audio Output 3.5mm jack, HDMI
  • USB 4 x USB 2.0 Connector
  • GPIO Connector 40-pin 2.54 mm (100 mil) expansion header: 2x20 strip Providing 27 GPIO pins as well as +3.3 V, +5 V and GND supply lines
  • Camera Connector 15-pin MIPI Camera Serial Interface (CSI-2)
  • JTAG Not populated
  • Display Connector Display Serial Interface (DSI) 15 way flat flex cable connector with two data lanes and a clock lane
  • Memory Card Slot Micro SDIO

Reset to factory default XXXResetDescription
Inclusion XXXInclusionDescription
Exclusion XXXExclusionDescription
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Technical Data

Dimensions 0.0206000x0.0140000x0.0388000 mm
Weight 39.2 gr
Frequency XXfrequency
Maximum transmission power XXantenna
Z-Wave Device