This is a
Dimmer control via sliding the button area.
Reset to factory default | Press and hold the Action button (20 seconds). The LED should blink between green, purple, then red which will flash rapidly until a green LED becomes solid for 2 seconds to indicate a successful factory reset. Let go of the Action Button. |
Inclusion | Press the Action Button on your WallMote Quad. |
Exclusion | Press the Action Button on your WallMote Quad. |
NIF | Press Action Button |
Wakeup | Remove your WallMote Quad unit from its Back Mounting Plate, press and hold the Action Button for 3 seconds(the buzzer chirp once and the orange LED will be ON) on the back of the WallMote Quad unit and then release it. This will trigger and send a wake up notification command to your controller/gateway, then your WallMote Quad will wake up for 10 minutes and the orange LED will fast blink while it is awake (if the WallMote Quad does not receive the Wake Up No More Info from the primary Controller). |
Protection | XXXProtection |
FirmwareUpdate | The WallMote Quad is also a security Z-Wave device and supports Over The Air (OTA) feature for the products firmware upgrade. |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 1 | Lifeline - Central Scene control via Button 1 - 4 |
2 | 5 | On/Off conrtol via Button 1 |
3 | 5 | Dimmer control via Button 1 |
4 | 5 | On/Off conrtol via Button 2 |
5 | 5 | Dimmer control via Button 2 |
6 | 5 | On/Off conrtol via Button 3 |
7 | 5 | Dimmer control via Button 3 |
8 | 5 | On/Off conrtol via Button 4 |
9 | 5 | Dimmer control via Button 4 |
Enable/disable the touch sound Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | Disable |
1 | Enable |
Enable/disable the touch vibration Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | Disable |
1 | Enable |
Enable/disable the function of button slide Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 | Disable |
1 | Enable |
To configure which report will be sent when pressing the buttons. Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
1 | Send Central Scene Command Notfication |
3 | Send Central Scene Command Notification an Configuration report |
Set the low battery value Size: 1 Byte, Default Value: 5
Setting | Description |
---|---|
5 - 50 | Low battery value 5% -50% |
Size: 4 Byte, Default Value: 1
Setting | Description |
---|---|
0 | Reset to factory setting (Size 1) |
1431655765 | Reset to factory default setting and removed from the Z-Wave network (Size 4) |
Dimensions | 76 x76x 10 mm |
Weight | 69 gr |
Hardware Platform | ZM5202 |
EAN | 4251295701141 |
IP Class | IP 20 |
Voltage | 3,7 V |
Battery Type | * rechargable |
Device Type | WallMote |
Firmware Version | 01.04 |
Z-Wave Version | 04.21 |
Certification ID | ZC10-17035521 |
Z-Wave Product Id | 0x0086.0x0002.0x0082 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |