This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Built your own Smart Home Gateway with the Raspberry 1 B+ and a Z-Wave.Me Razberry module! You simply connect the Razberry with the Raspberry 1 B+ and follow the instruction in the supplied manual. The Z-Wave module includes one license for the very powerful Z-Wave software Z-Way. This allows you to automate your entire home with Z-Wave devices. The Z-Wave software provides many possibilities with applying the well-known JavaScript interface technology JSON on a built-in web server. Writing your own home automation apps was never easier and more affordable!
This package includes the Raspberry Pi 1 B+ and the Razberry module. It is only available as long as stock lasts!
Raspberry Pi B+ - Features:
For more information about the Razbery module please follow the link.
Note: This package is a softbundle and does not include an own packaging for the Kit. Both products are shipped in their original packaging.
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.0870000x0.0180000x0.0586400 mm |
Weight | 46 gr |
EAN | 4251295701370 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |