This is a
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-Wave device regardless of brand and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
The Z-Wave compatible smoke sensor from manufacturer Popp detects reliably emerging fires in your house and safes life and estate of your family. Recoginzing fires primary works free of radioactivity with the help of a photoelectric sensor, which reacts on smoke particle concentrations between 1.8 % and 3.1 %. Additionally, the smoke sensor contains a temperature sensor, which is used parallelly for detecting fires, avoiding false alarm and at the same time measuring the temperature in the room. According to the guideline DIN EN14604, the smoke sensor warns via a light signal and a siren. This siren has a defined volume of 85db in a distance of 3 meters. The device comes along with a modern design. It is easy to install and easy for professional installers to open for cleaning. A lock prevents the installation of the device without battery. The automatic self-calibration and self-test increase the reliability of the device. After the installation a manual system test can be done by pushing the key button on the device. The smoke sensor has a wireless connection to the Z-Wave network. The measured values of the temperature sensor and the current battery level can be read out by a Z-Wave controller. A regular status report of the sensor enables a comfortable centralized management of many devices. It generates different alarm signals that either are received and evaluated by a central Z-Wave controller or can control switching actions of other Z-Wave devices (e.g. turning on/ off the light) directly:
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Here are a few hints for network installation if things dont work as expected.
Dimensions | 0.0000000x0.0000000x0.0000000 mm |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |