Quickstart

This is a secure Binary Power Switch for XXXQFrequencyName. To run this device please connect it to your mains power supply. Inclusion and Exclusion are confirmed by a triple click of the button. Fast blinking LED indicates the factory reset state.

Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Product Description

This is a plug switch that can be placed between a wall outlet for type F plugs and electric devices, plugged in by cord. It can switch all loads up to 3500 W. The device is IP 20 rated and can therefore only be used in dry environments. Switching is controlled wirelessly using Z-Wave or locally applying a button. A multi color LED indicates the switching status and the assignment of the colors to the switching status can be defined by the user. The device will report any change of the switching status to a central gateway regardless the origin of the switch (local or wireless). A built in virtual power meter will report the power consumption of the load attached. However the user must configure the assumed constant power draw of the load. The local button can control the local load but can also be used to control other functions in a Z-Wave network. The device is certified and tested against all important European Safety Regulations and fully complies with the Z-Wave Plus standard. The device supports secure communication and the firmware can be upgraded over the air (OTA).

Installation

Just plug the device into a standard type F outlet.

Product Usage

The device is able to switch electric loads up to 3500 W and can be switched wirelessly or using the local button.

Local Operation
The local button allows to switch the device. A short press on the button toggles the switch. If it is in ON state the button turns off and respective in OFF state the button turns on. Automated Switch-Off Function (deactivated as default) If activated the switch will turn off automatically after a defined time. This function is particularly useful if the switch is turned on using a motion detector of any other type of sensor. In this case it is possible to further define the reaction of the switch on certain signals sent from a sensor. This allows a very flexible application of the plug switch outside the house.

Reset to factory default	Keeping the button pressed for 5 seconds will enter the configuration menu. A blinking blue LED indicates that this menu was entered. Short click of the button will change the configuration option and a long (min. 2 seconds) click confirms the selection. The following options are supported: • Red: Local reset
Inclusion	Tripple Click the button
Exclusion	Tripple Click the button
NIF	XXXNIF
Wakeup	XXXWakeupDescription
Protection	XXXProtection
FirmwareUpdate	Keeping the button pressed for 5 seconds will enter the configuration menu. A blinking blue LED indicates that this menu was entered. Short click of the button will change the configuration option and a long (min. 2 seconds) click confirms the selection. The following options are supported: • Blue: Confirm firmware update
SetAssociation	XXXSetAssociation

Association Groups:

Group Number	Maximum Nodes	Description
1	14	Lifeline
2	14	Control

Technical Data

Dimensions	60x110x70 mm
Weight	128 gr
Hardware Platform	ZM5202
EAN	0019962009006
IP Class	IP 20
Voltage	230 V
Load	3500 W
Device Type	On/Off Power Switch
Generic Device Class	Binary Switch
Specific Device Class	Binary Power Switch
Network Operation	Always On Slave
Firmware Version	01.00
Z-Wave Version	04.05
Z-Wave Product Id	0154.0003.0001
Frequency	Europe - 868,4 Mhz
Maximum transmission power	5 mW

Popp

Z-Wave Type F Plug-in Switch