Z-Wave.Me Z-Uno 2 - Z-Wave Board for Arduino (Z-Wave 700 series)

Product Description

The Z-Wave.Me Z-Uno 2 - Z-Wave Board for Arduino (Z-Wave 700 series) is the perfect solution for DIY-Scenarios! Connect LEDs, buttons, switches, motors, or any low voltage sensor including most of Arduino compatible sensors.

Create your own Z-Wave device by programming a sketch in simplified C language. Z-Wave.Me Z-Uno 2 is the perfect companion for your RaZberry gateway. Find more information at https://z-uno.z-wave.me

Features:

• Control any Arduino compatible peripherals
• Define your own logic by modifying your sketch
• Use Arduino IDE and language to write and upload sketches
• Easy-to-use
• Requires no knowledge of Z-Wave protocol
• Complete DIY solution
• Z-Wave 700 series

Hardware Specification:

• 40 kB Flash Flash memory for your sketches
• 8 kB RAM
• 2 kB EEPROM
• Z-Wave RF transmitter at 9.6/40/100 kbps
• 26 GPIO, 15 are 5V tollerant, 5 are able to wakeup device from deep sleep
• 4 ADC
• 4 PWM
• 3 UART
• 3 SPI
• 16 interrupts
• 1 I2C
• 2x 16 Bit timers, 1x 32 Bit timer (GPT)
• 1-Wire (software) (overlaps with special hardware controllers)
• 2 service LEDs
• 1 service button
• 1 user test LED
• CSEN interface for capacitive touch-buttons
• LDMA controller for fast data transfers
• 32Bit Cortex M4F @ 39Mhz CPU

Channel Types:

• Binary Switch
• Multilevel Switch
• Color Switch
• Binary Sensor
• Multilevel Sensor
• Meter

Z-Wave supported features:

• Z-Wave Plus V2 compliant
• Support of Z-Wave Smart Start technology
• Z-Wave Long Range support
• All Z-Wave frequencies
• AES 128 bit Security S2 and S0 modes
• OTA or USB Firmware updates
• Multichannel (32 channels)
• 32 Association groups
• Controls switches, dimmers, door locks and scenes
• Works with gateways and/or directly with other Z-Wave devices

Download high resolution images for Z-Wave.Me products.